Best Position For Boat Lift Bunks

best position for boat lift bunks

My boat is a 20′ open bow fiberglass hull with an inboard/outboard motor. from the keel there are two strakes along the hull, the distance to the outside strake is about 19″. the short bunks on the boat lift are about 30″ long (5″ wide).the lift has short bunks that run across the beam of the boat rather than the typical long bunks that. Position your boat on the lift so that the motor sits in the middle. your prop won't be close to hitting, it is the fins you need to pay attention to. raising your bunks all of the way up will just limit the boat going on if your water is low. my bunks are set up so that they pivot to conform to the hull.. Check out boat lift warehouse's great selection on new boat lift bunks and cradles! are your boat lift cradles and bunks rotting or falling apart? check out boat lift warehouse's great selection on new boat lift bunks and cradles! shop; articles; about us; contact; request an estimate; 877.468.5438. service hours: m-f 8:00am - 5:00pm est..

Shoremaster

best position for boat lift bunks My old boat had best of both worlds, pressure treated bunks with uhmw over the top of them, no carpet. uhmw is what the breweries use to cover the side rails of can conveyors. look at a can of beer, see many marks on it? first time i launched the boat with this set-up i was glade i was over water, slide right off on me.. My lift has 2 bunks, one per side and they sit about 17" apart on center. my trailer has 4 bunks, 2 per side, we tried to duplicate the inside bunks. #312091 - 05/02/07 07:28 am re: boat lift bunk adjustment?.